Side-Lite S30C Specification Sheet

S30C

ECONOMICAL ALTERNATIVE FOR ONE 2-PIN
COMPACT FLUORESCENT LAMP (WITH INTEGRAL STARTER)

APPLICATION

Table 1
OperatesOne 2-Pin Lamp
Wattage	Base
10, 13, 18, 26	G24d
13, 18, 26	GX24d

The S30C fluorescent emergency ballast works in conjunction with the AC ballast to convert new or existing compact fluorescent fixtures into emergency lighting. The emergency ballast consists of a high-temperature nickel cadmium battery, charger and electronic circuitry in one compact case. The S30C can be used with most 10W through 26W compact fluorescent lamps with integral starters, including (2-pin) quad or triple twin-tube compacts (see Table 1). It is also compatible with most electronic, standard, and energy saving AC ballasts. If used in an emergency-only fixture, no AC ballast is necessary. The S30C is not suitable for use in air handling heated air outlet fixtures, and wet, damp, or hazardous location fixtures. For information about specific lamps and ballast compatibility, please call us.

OPERATION

When AC power fails, the S30C immediately switches to the emergency mode operating one lamp at full light output for the first few seconds to start the lamp, then a reduced lumen output for a minimum of 90 minutes. When AC power is restored, the S30C automatically returns to the charging mode.

INSTALLATION

The S30C does not affect normal fixture operation and may be used with either a switched or unswitched fixture. If a switched fixture is used, an unswitched hot lead must be connected to the emergency ballast. The emergency ballast must be fed from the same branch circuit as the AC ballast. The S30C may be easily installed with a variety of compact fluorescent fixtures, however, some fixtures may not accommodate emergency equipment. In these situations, the S30C may be remote-installed up to half the distance the AC ballast manufacturer recommends remoting the AC ballast from the lamp, or up to 50 feet, whichever is less. For installation on top of the fixture, model S30C provides two feet of flexible conduit at each end of the ballast. Installation is not recommended with fixtures where the ambient temperature may fall below 0°C for extended periods. For simple visual inspection of the charging indicator light and operational testing, the test switch/monitor plate may be installed in the ceiling near the fixture or remote-installed by the fixture's wall switch.

UL and CODE COMPLIANCE

The S30C has been tested by Underwriters Laboratories in accordance with the standards set forth in UL924 - "Emergency Lighting and Power Equipment," and is UL Listed for factory installation or field retrofit. Emergency illumination time exceeds the National Electrical Code (NEC), Life Safety Code (NFPA-LSC) and UL 90-minute requirements.

BATTERY

Since high temperatures exist in fluorescent fixtures, the S30C uses a specially constructed, high-temperature nickel cadmium battery. This battery requires no maintenance, and has a life expectancy of 7 to 10 years.

EMERGENCY ILLUMINATION

Table 2
Lamp Wattage	Lumen Output
26 W	650 Lumens
18 W	520 Lumens
13 W	350 Lumens
10 W	300 Lumens

Depending on the wattage and type of lamps selected, the S30C produces 300 to 650 lumens of emergency initial light output (See Table 2). During emergency illumination, one lamp is illuminated, even if installed with a multi-lamp AC ballast.

SPECIFICATION

Emergency lighting shall be provided by using a quad or triple twin-tube compact fluorescent fixture equipped with a S30C emergency ballast. This emergency ballast shall consist of a high-temperature, maintenance-free nickel cadmium battery, charger and electronic circuitry contained in one 9 3/8" x 2 3/8" x 1 1/2" metal case with two feet of flexible conduit at each end of the ballast. A test switch/monitor plate with test switch and charging indicator light shall be provided to monitor the charger and battery. The emergency ballast shall be capable of operating one _________ (wattage) [quad or triple] _________ (base) compact fluorescent lamp at _________ lumens (See Table 2) in the emergency mode for a minimum of 90 minutes. The S30C shall have 3.5 Watts of input power, a 14.4 Watt-hour battery capacity, and comply with emergency standards set forth by the current NEC. The emergency ballast shall be UL Listed for installation inside, on top of, or remote from the fixture, warranted for a full two years from date of purchase, and made in the U.S.A.

WARRANTY

Model S30C is warranted for two (2) full years from date of purchase. This warranty covers only properly installed SIDE-LITE emergency ballasts used under normal conditions. For the warranty period SIDE-LITE will, at its option, repair or replace without charge a defective emergency ballast, provided it is returned transportation prepaid, and our inspection determines it to be defective under terms of the warranty. Repair or replacement, as stated above, shall constitute the purchaser's exclusive warranty, which does not extend to transportation, installation, labor or any other charges; nor does it apply to any equipment of another manufacturer used in conjunction with the emergency ballast.

Product Summary
UL Listed	Factory or Field Installation
Initial Light Output	300 - 650 Lumens
Illumination Time	90 Minutes
Test Switch	Single Pole
Charging Indicator Light	LED
Recharge Time	24 Hours
Ballast Temperature Rating	0⁰ to + 55⁰C
Dual Input Voltage	120/277 VAC, 60 Hz
Input Current	270 mA
Battery	High Temperature, Maintenance-Free Nickel Cadmium Battery 7 to 10 Year Life Expectancy
Electrical Rating	3.5 W
Warranty	2 Years (NOT pro-rata)
Weight	2.8 lbs.
Dimensions	9.4" x 2.4" x 1.5" (238 mm x 60 mm x 38 mm) Mounting center 8.9" (226 mm)